Skip to content

IPv6 Causes Some Sites or Nodes to Fail ​

IPv4 and IPv6 can take different routes and use different DNS answers. If some destinations fail while others work, do not disable IPv6 immediately; first confirm that it is actually involved.

Compare both paths ​

Check whether the failure affects every site or only IPv6-capable destinations. If your tools allow it, test IPv4 and IPv6 separately and compare the result with the proxy enabled and disabled. A difference points toward routing, DNS or endpoint support rather than proving that IPv6 itself is bad.

Check the client configuration ​

Look for IPv6 options in the client, TUN settings and routing rules. A profile may route IPv4 through the proxy while handling IPv6 differently. DNS can also return an IPv6 address even when the intended path does not support it.

Temporary test, not a permanent fix ​

Disabling IPv6 can help isolate the cause, but it changes the device's network behavior and may break services that rely on IPv6. If you test with it disabled, record the original setting and restore it afterwards unless you know why it must remain off.

If the issue persists ​

Try a different node and network, then compare logs. If only one destination fails, it may be a destination-specific route issue. If many destinations fail only when the proxy is enabled, inspect the client's IPv6 and DNS handling.

Related: DNS guide and system proxy vs TUN.

VPN Finder · VPN, proxy and network tool guides